Similar to the normal weight specimen
loaded in fatigue (SCC-2), for load-set 5 of SCLC-2 the Load Ratio was slightly higher than for the other two specimens.
From the beginning of drying to the 48-hour drying time, the volumetric shrinkages of the
loaded LT, the
loaded LR, and the
loaded RT specimens were considerably higher than that of the load-free specimen.
Posterior bulge of intervertebral discs during unloaded (UL) and axially
loaded (AL) conditions.
Goods may be improperly
loaded into containers, or containers onto vessels.
Should quality issues be addressed by a data cleanup or "massaging" effort while the data is in the old familiar system, or should a final data cleanup occur after the data is
loaded into the new system?
By comparison, my desktop computer--a 66-Mhz 486 with twice the RAM of the laptop--which is
loaded with Windows 3.1, could barely handle a quarter of those applications, and certainly it could not perform a defragmentation at the same time.
According to the general requirements, a stack of crushed cars
loaded on a flatbed should require no more than three tie-downs with an aggregate WLL of at least 6,000 pounds.
When possible, don't leave magazines fully
loaded all the time.
As the equipment is
loaded onto a vessel, rail car, or truck, it is inspected and scanned again.
The resulting stress at the most
loaded spoke is approximately 150 MPa, which was above the fatigue strength under reversed bending stresses (80 MPa).
Cargo accelerates at the same speed as the truck on which it is
loaded. When the driver applies the brakes, the truck decelerates, yet the truck's brakes have no effect on the cargo within the vehicle, which continues to move forward.
To produce a more uniform separating three, grates contain magnetic material throughout the tube, and are not partially
loaded with springs and fillers.
The 598th Transportation Group-Forward
loaded all of the 173rd's equipment aboard the USNS Bellatrix in Ash-Shuaiba, Kuwait.
A rubber sample is rotated under
loaded tungsten carbide knives at controlled speed, time and force, and the amount of wear is reported.
This paper describes the behavior and failure modes of joints
loaded with dynamic forces that simulate hurricane wind and impact loads on residential structures.