pour

(redirected from poured)
Also found in: Dictionary, Thesaurus, Encyclopedia.
See:
References in periodicals archive ?
When they started with the milk, they poured about 10 percent more milk and 10 percent more cereal than when they poured the cereal first.
The bar molds should be at room temperature when poured. All molds must include a tracking system so that each bar can be identified with the casting it represents.
At the Spice Island Inn, guests sip on a SPICE ISLAND WHITE ROSE: 2 ounces of gin, 1 ounce of lime juice, the white of 1 egg, 1 ounce of orange juice and 1 ounce sugar syrup, shaken well and poured into a highball glass, garnished with a lime wedge.
In this process, a film/fabric seatcover laminate is vacuum formed into the mold, and foam is poured directly behind it, producing an integral seat in one operation with minimal manual labor.
PROBLEMS--Using manual pouring, a significant amount of iron was being poured on top of the mold.
To determine the optimal conditions of application of the coating for best wear resistance for each of the conditions tested, 12 to 16 castings were poured in two identical molds (Fig.
Sweet did not find out about the WTC steel until three or four months before the casting was slated to be poured. By that time, the ship had been designated the USS New York to commemorate the disaster of 9/11.
Metal was poured from the top at a constant rate to achieve the filling time of 2.5 seconds.
Because of its large quantity of components (1,620 active part numbers), Plant B possesses more than 40 of these furnaces, which it prefers due to the range of alloys poured. These furnaces sometimes are used as both a melting and holding unit.
Despite the potential for increased cleaning costs, risers were added to the gating systems, and molds were poured at higher temperatures.
However, the alloy is used almost exclusively in the sand casting process because it exhibits poor hot tearing resistance when poured into metal molds.
When metal is poured without any filtering device in the runner, a turbulent flow of metal reaches the gate before the runner is completely filled, entraining air in the process.
When molten iron is poured into a mold, heat from the metal is quickly transferred to the mold and the metal temperature falls.
Affecting such diverse areas as casting yield and safety and labor requirements, the selection of pouring technique and technology requires foundries to consider numerous factors, including type and grade of iron, casting weights to be poured and the scale of casting production.
They are caused by virtually all of the processes used to manufacture steel castings, As long as metal is poured through air and runs in a gating system that contains sand and more air it is virtually impossible to prevent inclusions from forming.