A well-known and much used solution to fixing onto non-metals, threaded inserts
can often provide higher torque or pull out performance by the application of heat or ultrasonic energy to further embed the insert
into its substrate.
Over-molding pins or threaded inserts
can allow one part to replace multiple parts and yet still be able to interface with its mating components.
After approval from the Institutional Ethics Committee, package inserts
accompanying allopathic medicines were obtained from a drug store and three pharmacies around a tertiary care centre in Western India on request over a 1-month period.
are boxed, they should fit the container (laid flat) firmly, without air space around the product that allows inserts
to shift within the box.
In feedblocks such as the Ultraflow I, specially machined flow inserts
are used to provide a target cross-direction thickness profile for each layer.
for the Ultraflow I feedblock that can be adjusted during coextrusion enable manufacturers of film and sheet to reduce downtime and material waste while permanent flow inserts
are prepared, as well as achieving greater precision in the ultimate thickness profiles of each layer across the width of the die, says the company.
What: New tool and insert
geometries for high-speed machining and mill-turn operations
All types of indexable cutting inserts
, that we will be tested, have a normalize shape SNGN 120716 T02020 and will be attached to the tool holder CSRNR 25x25 M12-K.
In addition, it can increase yield by reducing scrap due to error in assembly, significantly improve the consistency of parts, and reduce the tolerance stack-up of multiple inserts
in a single part.
This small effect results in pocket wear, which in turn allows for a greater degree of insert
In the present work, multilayer CVD coated ISO P-40, cemented carbide rhombic flat inserts
of ISO specification CNMG 120408 with chip breaker and composition WC=75.13 wt %, Co=21.22 wt%, TiC & TaC=3.65 wt % and a net coating thickness of 25 [micro]m (1st layer-TiN-1.5[micro]m, 2nd layer-TiCN-12.5[micro]m, 3rd layer-[Al.sub.2][O.sub.3]-6[micro]m, 4th layer-TiN-5[micro]m), were used.
The technological process of making the pump body pressure casting die concerned the making of the inserts
forming the casting shape on a pressure die-casting machine, i.e.
Separate month and year inserts
were installed, or a dual-ring insert
was put in place, marked with only the current year.
The center bar was set up with inserts
on the stationary and moving tools to make a foam section 0.197 in.
DrumSaver steel Drum inserts
significantly reduce container cleaning time and cost.