Most electronic loads using resistive elements are fabricated by end-users wanting high-power, low-cost solutions for their testing needs, sacrificing dynamic loading and programmable protection capabilities.
Metal oxide field effect transistors (MOSFETs) can be deployed as state-of-the-art electronic loads to address the limitations of resistor-based loads.
Cheng, "Effects of freeze-thaw cycles and seawater erosion on the behavior of reinforced air-entrained concrete beams with persistent
loads," Journal of Cold Regions Engineering, vol.
In the case of both batteries and diesel engines, the worst way of testing them is to switch them on or start them up without applying any
load. The only way to ensure that systems are functioning properly is to put them to work.
The study involved 34,348 people who had 158,385 pairs of CD4 counts and viral
loads measured from 1984 through 2011.
The FMs are now TM 4-48.10, Multiservice Helicopter Sling
Load: Single-Point
Load Rigging Procedures, and TM 4-48.11, Multiservice Helicopter Sling
Load Dual-Point
Load Rigging Procedures.
MULTAN -- The USAID Power Distribution Program successfully implemented the
Load Data Improvement (LDI) program at Multan Electric Power Company (MEPCO) to assist in minimizing unscheduled
load shedding.
In fact, many lines with very high tensile strengths that allow them to hold extremely heavy
loads have very low energy-absorbing capacities and can break easily when subjected to dynamic shock
load.
From the definition of the distribution of the random
load, it is easy to see that the longitudinal distribution reflects the probabilities that the
loads with different amplitudes occur at a determinate moment, while the transverse distribution reflects the proportion between the occurrence frequencies of the
loads with different magnitudes in the mission duration.
This article discusses plug
loads for common office applications.
The injection molding plant and the profile extrusion plant have broadly similar base
loads (both in magnitude and in percentage terms) but the extrusion site has a process
load only 30% of that of the injection molding site (0.4467 kwh/kg versus 1.5751 kwh/kg).
This study investigated the lateral shear and tensile
load resistances of glued face-to-face and end-to-face joints in southern yellow pine plywood and oriented strandboard (OSB).
This investigation aims to identify and address potential inconsistencies caused by application of AE criteria to a cyclic
load test profile, similar to the one used for the CLT method as described in ACI 437 [2], and to others that have been used in previous AE investigations.